Products > Test Equipment

how to connect sdg2000 to sds1000x hd for bode plot?

<< < (3/3)

tautech:

--- Quote from: simmiv on August 23, 2024, 01:13:47 am ---Siglent has a document detailing the setup for Bode Plot using their SDG series Gens..
One issue I encountered is the fact that my Series 5000 Arb Gen (SDG 5082) doesn't have a "Channel Copy Coupling" ability whereby you can sync the two channels under the control of the Oscilloscope as detailed in the instructions..   

--- End quote ---
Does the channel coupling function not work when the scope takes control of the arb ?
This was introduced in 5.01.01.15R1 FW in 2015.

Have you the last FW version from 2018 installed ?
https://int.siglent.com/upload_file/zip/firmware/Signal_generator/SDG5000_5.01.01.15R5_EN.zip

egonotto:
Hello,

For USB connection, the USB Device from the generator must be connected to a USB Host from the scope. The supplied USB cable will therefore work.

Best regards
egonotto

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod