EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: loki42 on April 14, 2019, 02:13:52 pm

Title: How to ignore initial power on spike in single mode (Rigol)
Post by: loki42 on April 14, 2019, 02:13:52 pm
I'm attempting to use my Rigol DS1054Z oscilloscope to work out why my MIPI DSI connection isn't working. Obviously a challenge is the high clock speed but I'm keen to check the lower clock stuff like TE and the reset line and this all changes on start up. How should I set the scope to single trigger mode but ignore the first spike from powering on? Is setting up a pulse trigger the right way? Is there a discussion anywhere on what to use the different trigger modes for?
Title: Re: How to ignore initial power on spike in single mode (Rigol)
Post by: Fungus on April 14, 2019, 07:48:00 pm
Is there a discussion anywhere on what to use the different trigger modes for?

There's a fine manual...  :popcorn: