Products > Test Equipment
HP 1741A oscilloscope - restoration project
<< < (33/33)
factory:

--- Quote from: electronix27 on August 09, 2024, 11:34:13 pm ---
Hi everyone, bit late to the party here.  Just picked up an HP 1740A, and enjoyed reading this post.  There are a few circuit issues but the CRT is in great condition.  Figured I’d start with a good cleaning.  Bit stumped on how to remove the sweep dial from the shaft.  Appears to be a small C clip on the notched shaft or maybe something I’m missing.  Appreciate your help.

Much Thanks

--- End quote ---

Those counting dials are used on a few HP scopes & plug-ins, it needs a special tool for the nut, the alternate is to make one, as I did.

David
electronix27:
Thank you sir.  I suspected this may be the case, but have not seen this on a potentiometer.  A tremendous help knowing, I’ll have to make one like yours.

Much appreciated
Russell
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod