Products > Test Equipment
HP 34401A 3457A 3456A 3478A Standalone Software
tv84:
Your animated .GIFs are awesome! :clap:
tomeo.gonzales:
You are amazing.
I must explore deeper your program :)
Thank you
Miti:
@Nx-1997
I like your software and I figured out what my issue was with the AR488 locking up.
I hope you don’t take it the wrong way if I say that this quality SW deserve to support one more quality instrument; Fluke 8845/8846.
Nx-1997:
Hi, Miti
Thanks for testing the software. Currently I am only creating software for the instruments I have, and I do not have a Fluke 8845/8846, sorry. However, source code is available, anyone with experience can use the code to create a software for other meters. The graph modules are completely independent, and can be ported to any software that needs a graph.
For AR488 version, the following commands are used.
++addr
++eor, only for 34401a
++auto
++ren, only for 3457A, 34401a
++read
++read_tmo_ms
++rst, only used if clicked on AR488 reset button.
++ver, only if clicked on AR488 version button.
All other settings for AR488 remain set to default. The above settings also change to default when sending ++rst command or unplugging the AR488 adapter from the USB port.
Also, some old instruments do not support *IDN? Command. So, one way to verify what instrument is connected to which COM port is to change the AR488’s firmware version string. So, when ++ver command is issued it will send a custom sting that includes the Instrument ID.
HKJ:
For the Fluke 8846A TestController https://www.eevblog.com/forum/testgear/program-that-can-log-from-many-multimeters/ can be used, it do also support a lot of other bench meters and devices, it runs on PC, Mac & Linux
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version