Products > Test Equipment

HP 34401A 3457A 3456A 3478A Standalone Software

<< < (12/19) > >>

Nx-1997:
I just tested it in Windows 7, works fine. The manuals says default settings are 9600, NONE/8 bits, Start Bit 1, Stop bit 2. On some meters the Parity and data bits may be set to Even / 7 bits by default.

todorp:
Ok, I managed to make it work: I am not sure what exactly was wrong but the default settings given by Nx-1997 worked. The only thing I did was to install Net Framework 4.7.2 dev sdk (I was getting ready to debug the source code). After this the software worked like charm.
Thanks a lot for everyone's help,
    Tod

jeffjmr:
New to GPIB, but have a 3478A and a Keithley 2015 and would like to log as well as learn about GPIB.

Will a UGPlus adapter work with this software and my 3478A?

If not, could you give me some specific adapter models that would work?

Any usability with my 2015?

Thanks,
Jeff

Nx-1997:
Hi, jeffjmr

The UGPlus adapter won't work with any of my software, unless you compile a special version for your UGPlus adapter. Because it is a true USB device not a virtual com port emulator like the AR488 gpib adapter.

I would recommend you try the ar488 adapter.
https://www.eevblog.com/forum/projects/ar488-arduino-based-gpib-adapter/

Step 1: get the ar488 pcb gerber files from user eliocor's post from this link and upload it to the jlpcb website:
https://www.eevblog.com/forum/projects/ar488-arduino-based-gpib-adapter/msg3362552/#msg3362552

Step 2: Get the Centronics Connector 57 Series 24 Pin Male (GPIB Connector), cheapest price:
https://www.aliexpress.com/item/32795413098.html?spm=a2g0o.store_pc_groupList.8148356.2.2d424321PJawwf
or https://www.aliexpress.com/item/32832215494.html?spm=a2g0o.store_pc_groupList.8148356.18.2d424321PJawwf

Step 3: Get some Arduino pro micros ATmega32U4 5V 16Mhz

Hope this helps, I created a bunch of these adapters following the above steps.

The Keithley 2015 has a serial port and uses SCPI commands, you can try the fluke 8846a compiled version I uploaded and see if that work.

jeffjmr:
That looks like an interesting project that would certainly test my SMD assembly skills. Not sure I have the patience for it at this point in time, though. I know nothing about Arduino. Don’t even understand your step 3.

 Is there an off-the-shelf adapter that would work? The only PC I have is a notebook with USB 2.0.

Besides the adapter, what else do I need beside your software and my PC?

If this is not the place for newbie advice, I understand and will try to educate myself a bit more on GPIB before proceeding.

Thanks,
Jeff

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod