Products > Test Equipment
HP 5335A Timer / Counter - Anything i should know?
<< < (12/34) > >>
Vgkid:
Thanks, it is starting to get loud. I will most likely get a new one, and fix the old one.
Also, can someone take a picture of the standby led mounting. I just have a hole where the led should be. I have opt 10 installed.
Vgkid:
Oh no...
powered it on today,noticed that the display stopped updating, reboot not reading my input. Checked the input on my scope, then ran the self test error 7.0. hooked the timebase out to the scope, i see a nice 10Mhz signal.
Crap.
PE1RKI:
service manuals:  :(
http://www.ko4bb.com/manuals/index.php?dir=HP_Agilent/HP_5335_Universal_Counter/HP_5335A_Operating_and_Service_Manual_%28hi-res%29
orin:

--- Quote from: Vgkid on April 15, 2015, 06:28:29 am ---Oh no...
powered it on today,noticed that the display stopped updating, reboot not reading my input. Checked the input on my scope, then ran the self test error 7.0. hooked the timebase out to the scope, i see a nice 10Mhz signal.
Crap.

--- End quote ---


Check your relay socket.  The first symptom is having the instrument start to act goofy.  See my previous posts on the subject.

Vgkid:
^^^ Will do, as it passed 7.0, and failed at 7.3 today.
how do you remove the metal clip holding in the relay, mine doesnt want to budge.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod