Products > Test Equipment
HP 70K/HP 70000 Modular Measurement System Thread
<< < (6/20) > >>
pquadrat:
At this time I have three 70000 systems, never could stop collecting these modules...

@K9DTV:
Do You have a 900/300 system running with the calibration software for the 70k system? I have a 900/382 controller with HP-UX running, but did not get it ready to talk to the 70k.

The system with the 70911A (Opt 001 (70Mhz IF), 004, 005) can connect to a 89600S system.

And I finally managed to upgrade the RAM/ROM Boards not only to current firmware, but also to 1MB RAM (Option "512"). If anyone is interested, I can post how to do it.

Peter
K9DTV:
yes, you never have just one  :-DD

I have 4 9000/300, only one running with a os and it's ws with basic 6.2 on top.
I have the software from hp on my PC, but dont understand how to get it installed on the 9000/300

I am running b.06.03 on the 70900b's with the DLP for the 70911a.



pquadrat:

--- Quote from: K9DTV on April 09, 2021, 08:38:53 am ---I am running b.06.03 on the 70900b's with the DLP for the 70911a.

--- End quote ---

I have to work out how to get the DLP to my 70900B, but at this moment I have no time for it.
I was able to get RM Basic running on HP-UX, and to start sthe 70k-Software, but I have to invest more time, which I do not have right now.
Do You know if the DLPs are in the software package? As far as I know, there is no way to save a DLP out of the 70900B?

-Peter
K9DTV:
@pquadrat

I do not think the DLPs are in the software package from HP's site.
It does have all the test and cal software for the system.
It also has the RAM software for units like the 70700.
I found no way to download the DLP from the 70900b to the ram card or disk drive unit.
Wish I know more about RMB and how they archived this software.

 
pquadrat:

--- Quote from: K9DTV on April 09, 2021, 09:06:06 am ---@pquadrat
....
Wish I know more about RMB and how they archived this software.

--- End quote ---

I think I did uncompress the software successfully, they did it under HP-UX. But I did it a year ago, so I have to take a look again.
Problem is, the file format of the basic files can only viewed under RM Basic, its no text file format.

For a HP 900 0300 running only RM basic without HP-UX, I think we need to create LIF fomatted floppy disks. I did this years ago with a DOS PC for other old HP stuff.

-Peter
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod