Products > Test Equipment
HP 70K/HP 70000 Modular Measurement System Thread
<< < (9/20) > >>
K9DTV:
In order to work with any of the 9000/300 software, I need to get my 382 up and running.
It's current state is no hard drive, I need an image of a working system With the cal and test software for the 70k.
Or some help in getting this setup.

Picture is of one complete system, but would like to get a 70620B and 70340A with two options.





Fixed typos.
K9DTV:

--- Quote from: tkamiya on April 30, 2021, 12:50:20 am ---HT Basic from here works.  Run time and development versions are pretty expensive but demo works for 30 minutes at a time.  (It can run under modern Windows)

https://transera.com/

--- End quote ---

I will have to check that out, thank you.
pquadrat:

--- Quote from: K9DTV on April 29, 2021, 10:32:50 pm ---
--- Quote from: pquadrat on April 29, 2021, 07:22:18 am ---
Demo DLP:
http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=HP_Agilent/HP_70000


--- End quote ---

The Demo DLP is for the 9000/300 computers, the stuff I am working with right now is the 70900 DLP

--- End quote ---

You are right! I expected it to be the Demo DLP package which I had on one of my 70900Bs. Still looking for it. It runs directly on the 70900B.
K9DTV:

--- Quote from: pquadrat on April 30, 2021, 02:15:57 pm ---
--- Quote from: K9DTV on April 29, 2021, 10:32:50 pm ---
--- Quote from: pquadrat on April 29, 2021, 07:22:18 am ---
Demo DLP:
http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=HP_Agilent/HP_70000


--- End quote ---

The Demo DLP is for the 9000/300 computers, the stuff I am working with right now is the 70900 DLP

--- End quote ---

You are right! I expected it to be the Demo DLP package which I had on one of my 70900Bs. Still looking for it. It runs directly on the 70900B.

--- End quote ---

I did some checking and this disk is to be run on the 70900 directly.
This manual talks about it on manual page 1-23 or pdf page 32

https://www.keysight.com/us/en/assets/9018-40123/installation-guides/9018-40123.pdf

Marian.MQH:
   Hello,
  I have an HP70k spectrum analyzer, consisting of the following blocks:

  HP 70601A RF ( 0...26,5GHz )
  HP 70906A Preselector ( 50k...26,5GHz
  and  70900A, 70903A, 70902A, 70004A 70311A

   I intend to improve its parameters by adding HP 70620A (Preamplifier 2-22GHz).
   My question is whether my HP 70k will work with this type of preamplifier (in its operating range 2..22GHz) ?

   Thank you in advance for any help.
 
   Marian
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod