Products > Test Equipment

HP 70K/HP 70000 Modular Measurement System Thread

<< < (9/20) > >>

K9DTV:
In order to work with any of the 9000/300 software, I need to get my 382 up and running.
It's current state is no hard drive, I need an image of a working system With the cal and test software for the 70k.
Or some help in getting this setup.

Picture is of one complete system, but would like to get a 70620B and 70340A with two options.





Fixed typos.

K9DTV:

--- Quote from: tkamiya on April 30, 2021, 12:50:20 am ---HT Basic from here works.  Run time and development versions are pretty expensive but demo works for 30 minutes at a time.  (It can run under modern Windows)

https://transera.com/

--- End quote ---

I will have to check that out, thank you.

pquadrat:

--- Quote from: K9DTV on April 29, 2021, 10:32:50 pm ---
--- Quote from: pquadrat on April 29, 2021, 07:22:18 am ---
Demo DLP:
http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=HP_Agilent/HP_70000


--- End quote ---

The Demo DLP is for the 9000/300 computers, the stuff I am working with right now is the 70900 DLP

--- End quote ---

You are right! I expected it to be the Demo DLP package which I had on one of my 70900Bs. Still looking for it. It runs directly on the 70900B.

K9DTV:

--- Quote from: pquadrat on April 30, 2021, 02:15:57 pm ---
--- Quote from: K9DTV on April 29, 2021, 10:32:50 pm ---
--- Quote from: pquadrat on April 29, 2021, 07:22:18 am ---
Demo DLP:
http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=HP_Agilent/HP_70000


--- End quote ---

The Demo DLP is for the 9000/300 computers, the stuff I am working with right now is the 70900 DLP

--- End quote ---

You are right! I expected it to be the Demo DLP package which I had on one of my 70900Bs. Still looking for it. It runs directly on the 70900B.

--- End quote ---

I did some checking and this disk is to be run on the 70900 directly.
This manual talks about it on manual page 1-23 or pdf page 32

https://www.keysight.com/us/en/assets/9018-40123/installation-guides/9018-40123.pdf

Marian.MQH:
   Hello,
  I have an HP70k spectrum analyzer, consisting of the following blocks:

  HP 70601A RF ( 0...26,5GHz )
  HP 70906A Preselector ( 50k...26,5GHz
  and  70900A, 70903A, 70902A, 70004A 70311A

   I intend to improve its parameters by adding HP 70620A (Preamplifier 2-22GHz).
   My question is whether my HP 70k will work with this type of preamplifier (in its operating range 2..22GHz) ?

   Thank you in advance for any help.
 
   Marian

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod