Products > Test Equipment
HP 8591A add a Tracking Generator
(1/1)
Crambone:
I have a good working HP 8591A and a friend gave me all the parts to add the tracking Gen. my question is after adding everything will the firmware automatically recognize the option?

Andrew
2nOrderEDO:
Did you tried installing the generator? It could be that the FW will automatically recognize the tracking generator once installed.

Best regards,
2nOrderEDO
ps:

--- Quote from: Crambone on February 11, 2023, 10:26:39 pm ---I have a good working HP 8591A and a friend gave me all the parts to add the tracking Gen. my question is after adding everything will the firmware automatically recognize the option?

--- End quote ---

Yes, it is recognized automatically.

There should be a sticker with two calibration coefficients ("SLOPE" and "OFFSET") somewhere in the donor unit. Keep this in a safe place when you remove the tracking generator.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod