Products > Test Equipment
HP 8591A add a Tracking Generator
(1/1)
Crambone:
I have a good working HP 8591A and a friend gave me all the parts to add the tracking Gen. my question is after adding everything will the firmware automatically recognize the option?
Andrew
2nOrderEDO:
Did you tried installing the generator? It could be that the FW will automatically recognize the tracking generator once installed.
Best regards,
2nOrderEDO
ps:
--- Quote from: Crambone on February 11, 2023, 10:26:39 pm ---I have a good working HP 8591A and a friend gave me all the parts to add the tracking Gen. my question is after adding everything will the firmware automatically recognize the option?
--- End quote ---
Yes, it is recognized automatically.
There should be a sticker with two calibration coefficients ("SLOPE" and "OFFSET") somewhere in the donor unit. Keep this in a safe place when you remove the tracking generator.
Navigation
[0] Message Index
Go to full version