| Products > Test Equipment |
| HP 8595E spectrum analyzer repair |
| << < (4/5) > >> |
| Gandalf_Sr:
I was looking at one of these on eBay the other day - am I right in saying that the tracking generator option only goes up to 2.9 GHz? Any other models I should consider? |
| MarkL:
--- Quote from: Gandalf_Sr on September 30, 2015, 04:23:04 pm ---I was looking at one of these on eBay the other day - am I right in saying that the tracking generator option only goes up to 2.9 GHz? Any other models I should consider? --- End quote --- You are correct. I see you've already started a separate thread for other model suggestions. |
| kada:
Thank you all for helping. After the YTO replacing the analyzer works fine. FREQ/AMPLITUDE calibration passes. I also have another 8595E with defective YTF :palm: But it works fine at the band B0 only (9 kHz - 2.9 GHz). |
| MarkL:
Glad you got it working! I also have two 8595E and one has the exact same problem that the YTF is dead, leaving band 0 still working. Thinking I couldn't make matters worse, I opened the YTF and one of the YIG sphere's rolled away. Doh! It had come off its mount. That's the end of that. "Fixed" it with a sticker on the front panel reminding me band 1 is dead. |
| AF6LJ:
--- Quote from: kada on October 09, 2015, 02:35:03 pm ---Thank you all for helping. After the YTO replacing the analyzer works fine. FREQ/AMPLITUDE calibration passes. I also have another 8595E with defective YTF :palm: But it works fine at the band B0 only (9 kHz - 2.9 GHz). --- End quote --- Glad to hear you got it working Great. :) :-+ |
| Navigation |
| Message Index |
| Next page |
| Previous page |