Products > Test Equipment
HP AGILENT E4433B ESG-D SERIES SIGNAL GENERATOR 250KHZ-4.0GHZ
syau:
Wonder if anybody have the code so that I can adjust (correct) the output level at 3-4GHz. My unit tend to drop 2dbm at 4GHz when measure with a power meter.
Symeon:
Hello everybody,
purchased an E4433BG unit,testing it the output frquency id pretty accurate butthe amplitude is problematic....for example,setting it to 0dBm/10 MHz it gives -0.12dBm upon switching on and after about half an hour of operation it goes down to -0.45 dBm it carries an elecronic attenuator,any idea if this is an attenuator problem or one or more active stages are suffering / changing as the temperature increases during operation? the unit was toroughly cleaned ,voltages checked on motherboard and are correct...any ideas? thank you. |O
roxbox:
EPSG software from HP https://roxbox.net/EPSG/
the above includes links to the downloads and links to just the README files
FixFuzzy
RemH98
Bluetooth waveforms for ESG-D and -DP
8648 Test Package
ESG E44XXB Test package
ESG AP/DP Test package
ESG E4438C Test package
Does anyone have links to other old HP adjustment software?
roxbox:
--- Quote from: tv84 on September 19, 2020, 08:27:37 pm ---
--- Quote from: PA0PBZ on September 19, 2020, 06:58:24 pm ---All I can see is a picture of a license generator... would be nice to have :-//
--- End quote ---
You definitely are not doing the homework! Google the generator and use it as shown.
Hint: Search for "lmcryptgui.rar".
--- End quote ---
Does anyone have a working link, every google link to lmcryptgui.rar seems to be a bust.
Got it, Thank You!
Tony_G:
Resurrecting an old thread in case someone has run into this.
While the thread was about the B series ESG SigGens, I have a C series ESG (E4438C) and when I try to use the associated service software I get an FMS Error "Could not retrieve model from Driver".
Did anyone suffer this and if so did you manage to solve it?
Thanks,
TonyG
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version