Products > Test Equipment
HP/Agilent half width gear rack mounted. Middle bracket?
(1/2) > >>
EE4all:
Ok, I have a lot of HP and Agilent gear rack mounted. Some of it is half width, so I have a piece of gear on the left side, and another on the right. I have always assumed HP had a center piece that just keyed into the other gear piece to hold them together, but never had seen one or found it with a search. Recently, I found a few of these on an old HP piece of test gear. I assume this is it. Where can I find more? What the heck did they call it, or is the part number?

themadhippy:
Not what your looking for,but apart from manufacturer specific,you can get universal joiners for example  https://www.canford.co.uk/Products/2026151/45-3360_CANFORD-JOINING-PLATE-For-half-rack-width-panel-1U
EE4all:
Right, that one won't help.

It's amazing that one can find rack mount flanges galore on  eBay for far left and right, but not these center joining brackets.
EE4all:
Ok, after a bit of extra searching, I did figure this out.

It's called a lock link kit. The part number is  5061-9694.
TheSteve:
I get the feeling users ran without any center lock 99% of the time.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod