Products > Test Equipment
Identify test point connector Philips PM5193
(1/1)
gmac34:
Hi, I wanted to go trough the calibration procedure for my Philips function generator, but this involves hooking up to a series of test points that have a coaxial connector that I cannot recognise, the manual mentions that the service kit would include cable adaptors but doesn't seem to mention the connectors in the part list.
Before I MacGyver something, does someone recognise them, so I can search for a matching connector?
Thanks !
Kim Christensen:
It almost looks like something you could insert a scope probe into.
gmac34:
I thought that as well, the inner diameter of the ground is 3.5mm which is a standard probe size, but the center pin is not a "tube", it's just a pin, this on the board appear to be the male side of this standard, so a probe would not mate there properly.
Navigation
[0] Message Index
Go to full version