Products > Test Equipment

Incorrect values ​​in 0.1uf capacitor measurement

<< < (3/6) > >>

NE666:

--- Quote from: TA3UIS on December 02, 2024, 09:00:48 am ---These are the 0.47uF capacitor measurements

--- End quote ---

Well, that suggests that your meters are in broad agreement, limited by their own resolution/accuracy/calibration/test freq.

Hence, your "0.1" capacitors are almost certainly junk.

TA3UIS:
These are the 1uF capacitor measurements

TA3UIS:
I guess the 0.1uF ones are garbage as you said. Maybe the 0.22uF ones too?

Here is another 0.1uF capacitor measurement from the same series.

Atlan:
First, try to shape the capacitors a little under voltage, and discharge them before measuring.  If it's the small low-profile capacitors, I don't use them as a rule, since they hit me with their leakage current.  They don't even have vitality, who knows what - especially if it's not a well-known brand.

TA3UIS:
I will try this when I have time.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod