Products > Test Equipment
Infinium scope 54815A upgrade (please help to find the right post) to 54825A
(1/1)
Warhawk:
Guys, there was somewhere a post that describes how to "upgrade" HP Infinium 5481x scope to higher version. If I remember correctly, there is somewhere a resistor to add or remove on the ACQ board close to the oscillator.
However, I don't remember more. Does anyone know, please? I have the unit opened now. :)
Warhawk:
Found it, if search engine brings you here, it is post #223 in thread:
https://www.eevblog.com/forum/testgear/agilent-54835a-scope-(4-channel-1ghz-4gss)-repair-uphack/200/

Short R134 close to the DIP oscillator and run the calibration afterwards.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod