Products > Test Equipment

Infinium scope 54815A upgrade (please help to find the right post) to 54825A

(1/1)

Warhawk:
Guys, there was somewhere a post that describes how to "upgrade" HP Infinium 5481x scope to higher version. If I remember correctly, there is somewhere a resistor to add or remove on the ACQ board close to the oscillator.
However, I don't remember more. Does anyone know, please? I have the unit opened now. :)

Warhawk:
Found it, if search engine brings you here, it is post #223 in thread:
https://www.eevblog.com/forum/testgear/agilent-54835a-scope-(4-channel-1ghz-4gss)-repair-uphack/200/

Short R134 close to the DIP oscillator and run the calibration afterwards.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod