« previous next »
Pages: [1]   Go Down

Author Topic: DS2000 Series Scope Self Calibration  (Read 1704 times)

0 Members and 1 Guest are viewing this topic.

Offline bluesmokeTopic starter

  • Contributor
  • Posts: 24
  • Country: us
DS2000 Series Scope Self Calibration
« on: July 23, 2013, 01:13:02 am »
Whats the correct procedure to do a self calibration on a DS2000 series scope, apart from letting it warm up 30 minutes or so?
What is confusing me is that in the manual it explains connecting the back trigger out connector to the 2 channels and trigger in but when you go to calibrate it says to make sure no signals are on the input channels!
« Last Edit: July 23, 2013, 01:45:12 am by bluesmoke »
Logged
 

Offline ddavidebor

  • Super Contributor
  • ***
  • Posts: 1190
  • Country: gb
    • Smartbox AT
DS2000 Series Scope Self Calibration
« Reply #1 on: July 23, 2013, 03:06:41 am »
No signal is right
Logged
David - Professional Engineer - Medical Devices and Tablet Computers at Smartbox AT
Side businesses: Altium Industry Expert writer, http://fermium.ltd.uk (Scientific Equiment), http://chinesecleavers.co.uk (Cutlery),
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee