Products > Test Equipment
Is there a better power supply option for $700?
<< < (10/11) > >>
Smokey:

--- Quote from: Jeroen3 on January 03, 2024, 07:20:54 pm ---...it's very responsive on the communication ports....

--- End quote ---

I looked through the documents and I didn't see a spec for communication speed/update rate.  Do you know what the actual spec is for this on the GPP-4323?

(My quest for bench supply -> poor mans SMU continues.....  This actually ticks a lot of boxes if it has source/sink and a fast update)

For reference, this was my thread about Rigol command processing time.
https://www.eevblog.com/forum/testgear/rigol-dp832-remote-command-update-rate/
JJ_023:

--- Quote from: nctnico on January 04, 2024, 11:54:12 pm ---
--- Quote from: JJ_023 on January 04, 2024, 11:28:27 pm ---I am not 1 of these people that is bothered by fan noise.  I am surprised at how many people are distracted by this. 

--- End quote ---
Wait until you get a bit older. Fan noise will become a nuisance. It is easier to concentrate on a difficult problem in a quiet environment.

--- End quote ---

I get what you are saying.  Certain noises definitely bother me.  But what's funny is I sometimes use a loud fan to drown out the noises that do bother me when I need to concentrate on certain documents for equations.  It also helps me sleep.  :)
JJ_023:

--- Quote from: Smokey on January 05, 2024, 01:00:10 am ---
--- Quote from: Jeroen3 on January 03, 2024, 07:20:54 pm ---...it's very responsive on the communication ports....

--- End quote ---

I looked through the documents and I didn't see a spec for communication speed/update rate.  Do you know what the actual spec is for this on the GPP-4323?

(My quest for bench supply -> poor mans SMU continues.....  This actually ticks a lot of boxes if it has source/sink and a fast update)

For reference, this was my thread about Rigol command processing time.
https://www.eevblog.com/forum/testgear/rigol-dp832-remote-command-update-rate/

--- End quote ---

All I remember is that it had a 115200 transmission baud rate via USB.  That's from the manual not the datasheet.
Smokey:
What I'm interested in are the command processing time and the minimum dwell time for remote commands.  But then again I'm a crazy person so none of this should really impact your decision unless you are also the same type of crazy.
JJ_023:

--- Quote from: Smokey on January 05, 2024, 03:34:44 am ---What I'm interested in are the command processing time and the minimum dwell time for remote commands.  But then again I'm a crazy person so none of this should really impact your decision unless you are also the same type of crazy.

--- End quote ---

Right now I don't really have any of those needs but who knows down the road I might lose my sanity and have the same exact type of need.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod