Products > Test Equipment

Is there a better power supply option for $700?

<< < (10/11) > >>

Smokey:

--- Quote from: Jeroen3 on January 03, 2024, 07:20:54 pm ---...it's very responsive on the communication ports....

--- End quote ---

I looked through the documents and I didn't see a spec for communication speed/update rate.  Do you know what the actual spec is for this on the GPP-4323?

(My quest for bench supply -> poor mans SMU continues.....  This actually ticks a lot of boxes if it has source/sink and a fast update)

For reference, this was my thread about Rigol command processing time.
https://www.eevblog.com/forum/testgear/rigol-dp832-remote-command-update-rate/

JJ_023:

--- Quote from: nctnico on January 04, 2024, 11:54:12 pm ---
--- Quote from: JJ_023 on January 04, 2024, 11:28:27 pm ---I am not 1 of these people that is bothered by fan noise.  I am surprised at how many people are distracted by this. 

--- End quote ---
Wait until you get a bit older. Fan noise will become a nuisance. It is easier to concentrate on a difficult problem in a quiet environment.

--- End quote ---

I get what you are saying.  Certain noises definitely bother me.  But what's funny is I sometimes use a loud fan to drown out the noises that do bother me when I need to concentrate on certain documents for equations.  It also helps me sleep.  :)

JJ_023:

--- Quote from: Smokey on January 05, 2024, 01:00:10 am ---
--- Quote from: Jeroen3 on January 03, 2024, 07:20:54 pm ---...it's very responsive on the communication ports....

--- End quote ---

I looked through the documents and I didn't see a spec for communication speed/update rate.  Do you know what the actual spec is for this on the GPP-4323?

(My quest for bench supply -> poor mans SMU continues.....  This actually ticks a lot of boxes if it has source/sink and a fast update)

For reference, this was my thread about Rigol command processing time.
https://www.eevblog.com/forum/testgear/rigol-dp832-remote-command-update-rate/

--- End quote ---

All I remember is that it had a 115200 transmission baud rate via USB.  That's from the manual not the datasheet.

Smokey:
What I'm interested in are the command processing time and the minimum dwell time for remote commands.  But then again I'm a crazy person so none of this should really impact your decision unless you are also the same type of crazy.

JJ_023:

--- Quote from: Smokey on January 05, 2024, 03:34:44 am ---What I'm interested in are the command processing time and the minimum dwell time for remote commands.  But then again I'm a crazy person so none of this should really impact your decision unless you are also the same type of crazy.

--- End quote ---

Right now I don't really have any of those needs but who knows down the road I might lose my sanity and have the same exact type of need.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod