Products > Test Equipment
Is there a LCR meter, which has default mode of C/ESR measurement?
(1/4) > >>
LinuxHata:
Hello.
I have Victor VC-4080 and DER EE5000.
Both have same issue, once powered on, they start with "LCR Auto" and not showing ESR, but showing something different, and frequency set to 1khz.
So each time I power them on, I have to cycle thru the menus/options to change things, which is quite annoying.

So I'm looking for a decent, 4 wire LCR meter, which, once being set to measure capacitance at 100hz and ESR, when turned off and back on, remembers this mode and there's no need to change things all the time?

Thanks!
mawyatt:
Tonghui TH2830 and Hioki IM3536 LCR Meters are mains powered lab types and have 4 wire setups. These remember all the previous settings and even the previous calibration data, altho more expensive than the DE-5000.

Best,
LinuxHata:
Tonghui seems to be within my estimated budget, but it is huge, not portable, in terms that you can put it into drawer when needed (and I don't need LCR measurement that often), so I'd like to have more portable option, if possible....
Rydda:
The UNI-T UT622E remembers previous settings.
Per Hansson:
The Agilent / Keysight / U1731C / U1732C / U1733C allows you to change both the frequency and measure type you boot it up into, and allot of other things, but it is not 4-wire.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod