Products > Test Equipment
JBC Soldering Station CD-2BC - Complete Schematic & Analysis
<< < (3/8) > >>
Icchan:
I was looking through the schematics and I went over the ZCD and I just can't understand how it prevents the lower transistor from having Veb breakdown since lower transistor sees negative voltages in excess of -23.5v on the negative half cycle...
Unless there's something I missed?

Since both 23.5v and 12v secondaries have common ground, the AC voltage is swinging between +23.5v and -23.5v in respects to GND... right? :D

It's late at night... I might be overlooking something obvious here.

This seems like a learning opportunity if anyone cares to explain to me what I'm missing here ;D
shangaoren:
there is something i don't get in your schematics of reverse engineering :

i have two tips, one that seems to have the heater fried and the other that works. i tried to put both in hot water, measured voltage and resistance between every pins and this is what i get.

As i understand the results, the common is the tip body, heater is between body and middle pin and thermocouple is between first pin and body, did i miss something ? 
johnmx:

--- Quote from: shangaoren on March 09, 2020, 10:12:50 am ---there is something i don't get in your schematics of reverse engineering :

i have two tips, one that seems to have the heater fried and the other that works. i tried to put both in hot water, measured voltage and resistance between every pins and this is what i get.

As i understand the results, the common is the tip body, heater is between body and middle pin and thermocouple is between first pin and body, did i miss something ? 

--- End quote ---
Are you using a T245?
Other types may have different connections.

A picture is worth a thousand words (see attached).

shangaoren:
Yes, the broken one is a C245-789 and the other one is a c245-911
johnmx:

--- Quote from: shangaoren on March 09, 2020, 11:13:01 am ---Yes, the broken one is a C245-789 and the other one is a c245-911

--- End quote ---
As you can see from the attached picture on my last post, C3 is the common, C2 the heater and C1 the thermocouple.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod