Products > Test Equipment
JunTek PSG9080 Programmable Signal Generator (80 MHz - 300 MSa/s - 14-bit)
grumss:
I dont remember the settings for this screen shot, but it was noisy like this with all settings
See attachment for channel2 (which is fine)
radiolistener:
Which frequency did you used for the carrier (for failed screenshot)?
grumss:
The modulation was 1k /100% and i tested with the carrier frequency from 1Mhz all the way to 80Mhz... Think these screen shots were at a carrier frequency of 10Mhz
radiolistener:
just tested on my one, both channels works ok (screenshots from the first channel, 10 MHz carrier)
grumss:
Yep- thats how mine should look as well, i suspect i have a bad solder joint on one of the components... Anyway i have only had it a week or so, im not going to open it up and fix it unless i have to..
I dont think it is typical of the generator, I have just got one that wasnt QCed well enough..
Going through all the "have you followed the instructions?" stuff with the ebay seller as we speak.
(can understand this- but I AM NO BEGINNER
VK3XDK (used to design microwave stuff :)... still an easy search on google)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version