Products > Test Equipment
Jupiter HT Multimeter Marketing
<< < (5/6) > >>
joeqsmith:

--- Quote from: BILLPOD on May 11, 2023, 07:52:05 pm ---Get one over to Joe Smith's place PRONTO :scared:

--- End quote ---

Because it is an electrician's meter ability to measure fault currents and such,  it would be fun to play with it and see how it compares with my own meter.  I downloaded and had a look at the manual.  There's not a lot of details in there.     I had posted some data using mine to measure the outlets in my home and where I work to get a higher fault current.  But mine is limited to CAT II.   You can set the load current for impedance measurements but I didn't see with this meter where you can set that or even what they are using.    About the best I could do is compare it against the meter I have.     Well, that and pull the thing apart, then transient test it to failure.  It better handle some small transients.   

***
Looks like $650 would cover it.
https://www.tequipment.net/HT-Instruments/Jupiter/Multimeters/
Someone:

--- Quote from: joeqsmith on May 11, 2023, 08:32:33 pm ---You can set the load current for impedance measurements but I didn't see with this meter where you can set that or even what they are using.
--- End quote ---
"non-trip" testing and the datasheet specifies 15mA and 100mA modes, so only 0.1 ohm resolution 5% + 0.3 ohm accuracy.
Hydrawerk:
HT Flashmeter is very similar to CEM DT-946. Only the case was redesigned.
https://www.ht-instruments.com/en/products/digital-multimeters/trms-multimeters/flashmeter/
https://www.cem-instruments.com/en/product-id-1623
Hydrawerk:
HT Ironmeter is very similar to CEM DT-966BT. Only keys were swapped.
https://www.ht-instruments.com/en/products/digital-multimeters/trms-multimeters/ironmeter/
https://www.cem-instruments.com/en/product-id-976
Hydrawerk:
HT63 is very similar to CEM DT-987.
https://www.cem-instruments.com/en/product-id-1392
https://www.ht-instruments.com/en/products/digital-multimeters/trms-multimeters/ht63/
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod