Products > Test Equipment
Keithley 2306 (2300 series) burst mode
(1/1)
w.v.s.:
Hello,
according to the specification of the "PULSE CURRENT MEASUREMENT OPERATION", there is a burst mode, which features current measurements with higher rates.
--- Quote ---BURST MODE:
Measurement Aperture: 33.3μs.
Conversion Rate: 3600/second, typical.
Number of Samples: 1 to 5000.
Transfer Samples Across IEEE Bus in Binary Mode: 4800 bytes/ second, typical.
--- End quote ---
I did not find in the manual how to set up such a burst measurement. Does anybody know or has an idea?
ch_scr:
The "Pulse current measurement procedure" is explained in the manual (this version of it, anyway) around page 69.
w.v.s.:
Thank you! They call it "Pulse current digitization" in the manual. I've missed that somehow earlier this day.
Navigation
[0] Message Index
Go to full version