Products > Test Equipment
Keithley 2400 SourceMeter review and teardown
<< < (4/24) > >>
TiN:
Seems this story have a happy ending after all :)

Got my unit calibrated by official Tek/Kei service.

Data before calibration
Data after calibration

So this will become a reference point/source from now on on my volt-nutting explorations.  :bullshit:

Btw, if anyone want - there is an broken 2400LV (no 200V range) poped up on bay recently: eBay auction: #201021188476.
robrenz:
Nice!  :-+
TiN:
Just got my bad boy back :)
Now have some reference point for volt-nut practice.



TiN:
2400LV for 750$ with faulty output :)
http://www.ebay.com/itm/Keithley-2400-LV-Sourcemeter-/201046424972
TiN:
Yey, Keithley still cares about 20 year old models...

New firmware released recently, in case someone with 2400 series SMU from Japan need it.
Why Japan?

Release notes:

Version C33 fixes the issue of powering up with a low line-voltage (90 volts in Japan) for models 2420, 2425, 2430, 2440. Upgrading to this version of firmware will add a 5-second delay to power-up for all models running it.

Models affected: 2400, 2400-C, 2410, 2410-C, 2420, 2420-C, 2425, 2425-C, 2430, 2430-C, 2440, 2440-C
Symptom: The instrument will power up, but the digital circuitry will not work properly. Therefore, there is voltage on the output and no readings are accurate.
Resolution: The issue has been corrected.
Enhancements: There were no enhancements included in this release.

Remirrored it on on docsite, as usual, in case you don't want login into Keithley's site.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod