EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: calexanian on November 16, 2013, 04:27:04 am
-
Anybody have a schematic for a Kenwood PR18-3 schematic? Its the type of design where everything needs to be crammed together and connected to get voltages, and you cant see anything that way. Flying blind. I see the first tap voltage (14 vdc) on the main filter caps. No power light, and no output. It was acting up and the short circuit cut out was tripping intermittently sitting there with no load, then dead. If i cant fix it or get a schematic in a reasonable time then in the scrap box it goes. I got my 15 years out of it so I am not upset.