Products > Test Equipment
Keysight 3000T scope 1 GHz(or more) hardware upgrade mod
<< < (10/27) > >>
mrpackethead:
Did you preheat the board?
mrpackethead:

--- Quote from: TheSteve on June 30, 2017, 04:05:23 am ---K1 - Teledyne A150-20-12 - 3104T only - This is the money part. I bought mine from a trusted vendor in China and verified they were 100% legit before install.
K2 - AGQ210S4H 3024T only (I recommend carefully removing using hotair)
K3 - AGQ210S4H 3104T only
***I don't recommend planning to re-use the removed AGQ210S4H relays - buy new ones***

--- End quote ---

Just a little confused by this..       



and can you share ( pm maybe ) the trusted source for the part.
Which bits are replaced if I'm going from a 3014T?   


adranp:
:mrpackethead

K1 has to installed (the most expensive part from the upgrade BOM and the most hard to get)
K2 has to be removed
K3 has to be installed (new part required due to hotair removal procedure which will most probably damage the part from K2)


Steve did not preheat the board as far as I know..

mrpackethead:
My scope is 20,000km away, so i dont' have one to look at.  :-)

K1 has to installed (the most expensive part from the upgrade BOM and the most hard to get) -    So this part is unpopulated?

K2 has to be removed -
K3 has to be installed (new part required due to hotair removal procedure which will most probably damage the part from K2)


In the photos it seems that both K2 and K3 are left installed??

Steve did not preheat the board as far as I know..
tautech:
See #17 in the OP.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod