Products > Test Equipment
Keysight 3000T scope 1 GHz(or more) hardware upgrade mod
<< < (17/27) > >>
adranp:
As I said previously, lifting the shields works best with pre-heater and hot-air gun. This way you won't have problems. Solder wick requires good skills.
EE-digger:
adranp: That's why I thought that a hot iron, slide some high temp, thin film under that corner.  Clean up after all four have been lifted.  I may give it a shot.  I have bottom heat but would rather not involve that side.  I know it would work great though  :)

Did you ever finish your mods?

Josef:  Sorry about your lifted copper.  That can be heartbreaking but glad that your scope works well  :-+

Samogon:
Got 4024A and being inspired by TheSteve will try to mod it to 1G or 1.5G with his and hopefully community help.

here are some pictures of areas we interested.
Samogon:
In ideal if someone can open little expensive 4104A or 4154A scope remove backside shield and make hirez pictures that would be fantastic.
Pinkus:
The "back" picture shows a lot of flux as if somebody already reworked this. Did they (Agilent) really deliver such a board?

The front end looks (almost) identical to the 3000 series, thus it should be not a big deal. Though the mod for 1.5 Ghz has afaik not been made yet.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod