Products > Test Equipment

Keysight's new 34465A (6.5 digit) and 34470A (7.5 digit) bench multimeters

<< < (42/145) > >>

saturation:
The full stat display is very helpful, I do all that by hand via a tedious PC connection analysis.   It shows the integrity of the measurement very quickly.


--- Quote from: HighVoltage on March 17, 2015, 07:40:54 am ---I kept the 2.5000 V reference hooked up over night and this is the result I am getting:
It looks to me,  that the reference and the 34470A are performing well.

--- End quote ---

radioFlash:
Is there a way to capture the date/time of a reading when doing externally triggering? When I setup external triggering and save the data to a .csv, it captures the start time of the capture, but not a time when each sample is taken. I've looked through the manual and couldn't find a way to do that without resorting to scripting.

6thimage:

--- Quote from: radioFlash on March 19, 2015, 05:23:25 pm ---Is there a way to capture the date/time of a reading when doing externally triggering? When I setup external triggering and save the data to a .csv, it captures the start time of the capture, but not a time when each sample is taken. I've looked through the manual and couldn't find a way to do that without resorting to scripting.

--- End quote ---

Unfortunately, I don't think there is, which seems like a bit of an oversight. It might be worth contacting Keysight and asking them to add this as a feature, as there is no obvious reason why the data logging couldn't output the time - I can understand that it might not be possible to get timestamps for the measurements in the internal memory, as I'm guessing the readings are just stored in an array.

6thimage:
I have had an update about the 34461A's firmware:


--- Quote from: Keysight ---Unfortunately the firmware release has been delayed until further notice as the engineers are performing some additional tests to make sure the firmware works as per the expectations

--- End quote ---

This has come from their contact centre, so I think "to make sure the firmware works as per the expectations" means they found a pretty significant bug in it. If they are fixing a bug, then it might delay the release further - as I get the impression that their firmware testing procedure takes a while to run.

dadler:
Just received my 34465a from Newark. Firmware is 2.06 as expected.

Any hope on, Um, getting the digitize and memory options for a price closer to free?  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod