Products > Test Equipment
Keysight's new 34465A (6.5 digit) and 34470A (7.5 digit) bench multimeters
<< < (120/145) > >>
blackdog:
Hi 0xfede,

Tested your software on one of my 34461A DMM's and it works!  :-DD
Sometimes its crashes and probely it has someting to do with the function "Release instrument after download" half of the time does not work properly.
Also the pictureviewer is not showing the hole pigture, if i save the picture and show it with Irfanview, than its OK.

Thanks for the program, keep op de good work!  :D

Picture is showing my +10V LAB Reference (about +2PPM to High) the 34461A is showing about +15PPM to high


Kind regards,
Blackdog
0xfede:

--- Quote from: blackdog on November 23, 2017, 02:17:15 pm ---Hi 0xfede,

Tested your software on one of my 34461A DMM's and it works!  :-DD
Sometimes its crashes and probely it has someting to do with the function "Release instrument after download" half of the time does not work properly.
Also the pictureviewer is not showing the hole pigture, if i save the picture and show it with Irfanview, than its OK.

Thanks for the program, keep op de good work!  :D

....................

Kind regards,
Blackdog


--- End quote ---

Hi blackdog, may I ask you to send a command via telnet and check if throw an error?
The command is:
SYSTem:LOCal

Thanks,
0xfede
blackdog:
Hi 0xfede,


This command gives a error on the instruments display: SYSTem:LOCal

SYST:LAB "Koffie met Koek" wil give the picture below and the "error" on the display is visible, the SYST:LAB workt normaly, after the error message appeared.


But sometimes i get this eror message and error message 113, Undefined header


It is not clear for me, why there is sometimes a error message on the screen.
I cant put my finger on it.

But wait...
Clicking a few times on the Download Data button gives a error!
Camera screenshot



I hope this helps a little...

Kind regards,
Bram
0xfede:
Thank you again blackdog.
So this command is also not supported on the 34461A and I can't use it for releasing the instrument from remote mode.
I'll figure out a trick for that. In the meantime do not use the release instrument after download feature.

Best,
0xfede
LA7SJA:
I regret to inform you that the "release instrument after download" feature works perfect on my
34461A A.02.14-02.40-02.14-00.49-01-01 (latest firmware)
22.11.2017  22:32            43 008 KEYSIGHT DMM plot.exe
28.08.2014  13:56           296 448 ZedGraph.dll

Johan-Fredrik
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod