Products > Test Equipment

Kirkby calibration kit alternatives?

<< < (37/44) > >>

tautech:

--- Quote from: Noy on November 13, 2020, 10:38:32 am ---Hi, is the suggested :
https://www.sdr-kits.net/index.php?route=product/product&path=66_68_69&product_id=50
Kit useable for up to 3.2GHz im thinking abaout buying / hacking a SSA3021X-Plus but additional >>100€ for a calkit is said, the SSA is expensive enough for me..?

--- End quote ---
Likely to be quite good enough for most measurements.
Doing a Cal with other than kits listed in the Cal menu you need save the file to the SVA file system and then apply it as a Correction.
All simple enough once you get your head around the process/method.

Looking forward to seeing your measurements.  :)

Noy:
 Is there a list which "official" calkits are supported from the cal menu?

Sometimes i think tautech is an inoffical siglent fae crew account (multiple fae behind this account..) or maybe a very smart siglent bot / KI.. :-D so many posts in so many threads where do you work beside posting ? :-D

tautech:

--- Quote from: Noy on November 13, 2020, 08:36:06 pm --- Is there a list which "official" calkits are supported from the cal menu?

--- End quote ---
The Siglent Cal kits of course are all supported plus the crossover ones listed in this document:
https://siglentna.com/wp-content/uploads/2020/08/Mechanical-Calibration-Kit-Datasheet.pdf

hendorog:

--- Quote from: Noy on November 13, 2020, 08:36:06 pm --- Is there a list which "official" calkits are supported from the cal menu?

Sometimes i think tautech is an inoffical siglent fae crew account (multiple fae behind this account..) or maybe a very smart siglent bot / KI.. :-D so many posts in so many threads where do you work beside posting ? :-D

--- End quote ---

He's definitely a bot. But a fully mechanical one. IC's weren't invented when he was built.

The Tauturk.

Noy:
Is it worth to pay the "extra" for the SDR Kits Calkit (box, load measurment, male male Adapter) instead of buying the parts as "single" from Mouser?
Refering to:
http://www.hhft.de/index.php?page=competences&subpage=calibration

Mouser: 56€ + 16% vat inkl. shipping
SDR Kit : 75€ inkl. Vat + shipping (85€ total)

I think same parts and i think the only measured thing from SDR kits is resistive load resistor..
I can do this also with 4 wire measurment with my fluke8840a or?
Or are there more measurment done by them?

Male - male Adapter is sure also available from Mouser (didnt searched , not sure if i need this one...)

Suggestions??

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod