Products > Test Equipment
Korad KWR102 power supply
<< < (3/4) > >>
WR3:
Well... I just made the fan modification. You just take the main cover off and then you can access it from the side.
Fans are always connected to the +12V, so in my case I only connected 2x460R in parallel to the ground bypassing the fan control circuit.

Korad fans are laud, so if you want more silence you have to change them.

knudch:
Few comments:
(KWR102)

Noise: approx 70mVpp at 12V/1.5A

Fans: when idle (after high load), I can hear it but not critical is total overruled by my SDS2104x+
At high load humming is surprisingly loud, FANS sound is acceptable for high load situations
edavid27:
Hello,

i have ordered the power supplies but there was no CD in the package.
Could you share the tools please ?
it will be helpful.
thank you
mawyatt:
Anyone have success with the Dynamic Setting Function or the Voltage & Current Slope Setting Function on the KWR102 or 103?

Best,
tooki:

--- Quote from: edavid27 on May 04, 2023, 11:26:08 am ---Hello,

i have ordered the power supplies but there was no CD in the package.
Could you share the tools please ?
it will be helpful.
thank you

--- End quote ---
https://www.koradtechnology.com/companyfile/6/
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod