Products > Test Equipment
Korad KWR102 power supply
WR3:
Well... I just made the fan modification. You just take the main cover off and then you can access it from the side.
Fans are always connected to the +12V, so in my case I only connected 2x460R in parallel to the ground bypassing the fan control circuit.
Korad fans are laud, so if you want more silence you have to change them.
knudch:
Few comments:
(KWR102)
Noise: approx 70mVpp at 12V/1.5A
Fans: when idle (after high load), I can hear it but not critical is total overruled by my SDS2104x+
At high load humming is surprisingly loud, FANS sound is acceptable for high load situations
edavid27:
Hello,
i have ordered the power supplies but there was no CD in the package.
Could you share the tools please ?
it will be helpful.
thank you
mawyatt:
Anyone have success with the Dynamic Setting Function or the Voltage & Current Slope Setting Function on the KWR102 or 103?
Best,
tooki:
--- Quote from: edavid27 on May 04, 2023, 11:26:08 am ---Hello,
i have ordered the power supplies but there was no CD in the package.
Could you share the tools please ?
it will be helpful.
thank you
--- End quote ---
https://www.koradtechnology.com/companyfile/6/
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version