You design the circuit boards in your sleep, don't you...

I probably won't finish populating my circuit board until I've bought a new soldering station; I'm not satisfied with the one I have now.
In principle, I find the idea of being able to test as much as possible with a single board appealing.
The design so that the Kelvin clamps fit is also good.
If I were to design something like this, however, I would reduce the number of measuring components and implement the line paths as shown on the L/C option of DMM Check+.
Even if it wouldn't be necessary due to the option of using Kelvin lines, it would be for gut feeling.

Maybe I will do that, because we had two options to choose from.