Products > Test Equipment
LCR meter questions and maybe recommendation.
Martin72:
--- Quote ---ST42 is a great device and we are to market them in NZ
--- End quote ---
Ah, then everything is clear. ;)
I don't want to spoil your business, you know that.
But you have to make things clear and one thing is that the ST42 (in my eyes) is not enough to cover everything, but that is exactly what is always suggested.
The obvious thing is that mechanically alone you reach your limits when it comes to measuring normal wired components.
tautech:
--- Quote from: Martin72 on June 03, 2024, 09:43:04 pm ---
--- Quote ---ST42 is a great device and we are to market them in NZ
--- End quote ---
Ah, then everything is clear. ;)
I don't want to spoil your business, you know that.
But you have to make things clear and one thing is that the ST42 (in my eyes) is not enough to cover everything, but that is exactly what is always suggested.
The obvious thing is that mechanically alone you reach your limits when it comes to measuring normal wired components.
--- End quote ---
:)
For 2 decades I have spread SMD tweezers wide enough to measure all manner of components.
With ~50mm possible not much is exempt from obtaining a measurement and I have soldered wires on larger components .....
In time you will find these capabilities. ;)
Martin72:
If I buy the ST42, I will also test it and report on it, you should have that in mind. ;)
KungFuJosh:
--- Quote from: Martin72 on June 03, 2024, 10:11:11 pm ---If I buy the ST42, I will also test it and report on it, you should have that in mind. ;)
--- End quote ---
🤣🤣🤣 We all know it's when, not if. 😉
I have no interest or benefit from praising the ST42, and I also believe they're great. Like any TE though, know it's uses and limits.
Attached is the inductance measurement from when I was still using buggy firmware on my bench LCR. The ST42 helped with sanity checks and finding the issues (that were eventually corrected) in the bench LCR.
Martin72:
--- Quote ---We all know it's when, not if
--- End quote ---
The fact that I hate talking about things I don't know personally, unlike quite a few people who have no problem doing the exact opposite, makes the way I do my hobby a bit more expensive. ;)
But for the “good” of all forum members.
And yes, I have just bought the miracle part for 143€. 8)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version