Products > Test Equipment
LCR6200 inductance meter
(1/1)
Faringdon:
Hi,
Do you know what source resistance to choose..its either 30R, 50R, or 100R?
Also, what does the "L force" input mean?
Also, "H force"?
I measured some inductors but its well inaccurate.
I  did all the opan and short calibration/initialisation steps.

LCR6200
https://www.farnell.com/datasheets/2267000.pdf
coromonadalix:
Do you work with kelvin probes ?   show photos of your probes

the "L" side  will touch together on one side on the part to be measured

Same for the "H" side

https://www.allaboutcircuits.com/textbook/direct-current/chpt-8/kelvin-resistance-measurement/

Unless some damages happened ?
Faringdon:
I am getting a Lsec measurement of 7.5uH...and primary of 480uH.
Thats 8:1 and it surely cant be that much in this design.
I am wondering if the intercoil capacitance is making the sec coil inductance look much lower than it really is.?

The Sec coil, with the "Ls-Q" measurement comes out as 7.5uH and Q=12.
Q=12 sounds high, i am wondering if there is loads of intercoil capacitance and the inductance reading is thus coming out low.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod