Products > Test Equipment
LCRZ Meters, Chart ?
(1/6) > >>
Randy222:
Is there on EEVb a chart that lists out the relatively good LCR meters using community feedback, in a chart or the like?
I just trying to get a sense of what meters are better than others, and for what reasons, like "best value", "most accurate", "better precision", "better resolution", etc.
KungFuJosh:
I haven't seen one.

The short list is:

DE-5000 - accurate / best value / handheld meter

TH2830 or 2832 / ST2830 or 2832 - Best lowish cost lab grade bench meters (Tonghui TH is terrible support, SourceTronic ST has excellent support).

Hioki IM3536 - excellent lab grade bench meter.

Instek LCR-8200 series - very expensive lab grade / high frequency meters.

There's also some less reliable, but usable bench meters from East Tester.

coromonadalix:

--- Quote from: KungFuJosh on December 29, 2023, 04:17:07 pm ---I haven't seen one.

The short list is:

DE-5000 - accurate / best value / handheld meter

TH2830 or 2832 / ST2830 or 2832 - Best lowish cost lab grade bench meters (Tonghui TH is terrible support, SourceTronic ST has excellent support).

Hioki IM3536 - excellent lab grade bench meter.

Instek LCR-8200 series - very expensive lab grade / high frequency meters.

There's also some less reliable, but usable bench meters from East Tester.

--- End quote ---


the DE-5000  is built around 2 ic's,  Mastech  lcr as them, Uni-t  old series,  and other clones

now  maybe in the middle range
Many of the ET-430 and up models, new Uni-T
Hantek 1832 1833


100khz  is a basic requirement  nowadays

and i hope  you discern precision vs resolution ...
Randy222:

--- Quote from: coromonadalix on December 29, 2023, 04:32:48 pm ---

and i hope  you discern precision vs resolution ...

--- End quote ---
100%. I am well versed with accuracy vs precision vs resolution. They are 3 terms often not understood.

Now I go lool at the various listed models.
coromonadalix:
really depend of your need

serial parallel   ecr dcr   etc ....   resolution 20000 40000 counts

interfacing

lots of portables one if not all, dont do supplemental DC biais voltages,  just the bench ones

or need special cases  like sencore lc102 lc103   who will really do 1kv tests ???  they are the only ones at an astonishing price

even thoses  little component tester can do wonders ... 20$ is not excessive, Fw Hw support

and only some of the high ends will discharge the caps before measurements, all the portables low medium costs  will bust, even some middle high end ones  etc ...
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod