| Products > Test Equipment |
| LeCroy 3034 - how to set up ARINC429 data display? |
| << < (5/5) |
| 2N3055:
Like I said already, my theory is that someone used "homemade" key to enable ARINC on a scope that doesn't support that. Scope is now behaving weirdly.. All LeCroy MAUI scopes use same windows software for PC based platforms. For embedded platforms like WS3000 some porting was done to WinCE (ARM) and it is possible that license manager was ported in full. And it is known thing that license manager doesn't really check options much for validity for specific platforms. There are many occasions where users of x86 based scopes had problems after enabling options their particular model didn't support. License manager happily let you do so, and later you had problems with scope. Normally you don't have that problem because LeCroy wouldn't sell you option that is invalid for your scope. Your scope never had and never will support ARINC. Even if LeCroy decides to add ARINC (and/or other avionics protocols) to WS3000 class device they will do it for new, current model 3000Z. |
| peter-h:
Is there some way to reset the scope, but without losing the installed options? I will try it on SPI at some stage but it takes a lot of setting up (access to signals etc). RS232 would be a lot easier; I have a signal handy so will try that sooner. What were the "later problems with a scope"? Did new software keys stop existing options working? |
| Azusa:
Hi peter: How you generated the key for ws3000? I tried the script on forum but it doesn't work at this model. |
| Navigation |
| Message Index |
| Previous page |