Products > Test Equipment

Lecroy Wavepro 7k - how to save auto-cal settings?

(1/1)

mrcy22:
I'm talking about saving this setting in the service menu. Every time I turn off the oscilloscope, the settings are reset to the values as in the photo.

Nx-1997:
The settings in the Service menu cannot be saved as they are not meant to be accessible by regular users on a daily basis, I think. Also, I am curious do you also get these peaks with no signal attached to the input channel. All my lecroy scopes show these peaks.

mrcy22:
It's similar to yours.

DaJMasta:
I think those are the subsets of the saved autocal routine references you can redo from that menu, not a selection of which ones are performed when the instrument autocals.

To the other poster, yes you get some peaks in the lower range of the FFT which is internal clock generation spurs coming through.

mrcy22:

--- Quote from: DaJMasta on October 11, 2023, 05:23:12 am ---I think those are the subsets of the saved autocal routine references you can redo from that menu, not a selection of which ones are performed when the instrument autocals.
--- End quote ---

It's really turning off the autocalibration. When switching ranges (both vertical and horizontal) there is a few seconds of autocalibration which is an annoying delay when I don't need to know the exact signal parameters. If I turn off the above options, everything goes quickly without autocalibration.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod