Products > Test Equipment
Linux on CRTU-RU (o;
davorin:
Hmm...cvt tool doesn't help get an X display on the built-in LCD or external VGA....
Guess some DSO hookup to the VGA signals and calculate the ModeLine values by hand...well if the LCD and VGA signals share the same timing...
kfitch42:
--- Quote from: fisafisa on November 08, 2015, 04:56:52 pm ---Also useful, under linux, would be a way to map these addresses to user-space, so that one can test things without need to write drivers.
--- End quote ---
/dev/mem will do that. Something like:
int fd = open("/dev/mem",O_RDWR|O_SYNC);
unsigned char* RxTxMem1 = (unsigned char *) mmap(0, getpagesize(), PROT_READ|PROT_WRITE, MAP_SHARED, fd, 0x000D4000);
unsigned char* RxTxMem2 = (unsigned char *) mmap(0, getpagesize(), PROT_READ|PROT_WRITE, MAP_SHARED, fd, 0x000D5000);
Also, accessing I/O ports from user space is pretty simple:
#include <sys/io.h>
//...
ioperm(0x0100, 0x10, 1);
ioperm(0x0140, 0x30, 1);
//...
uint8_t val8 = inb(0x100); // 8-bit wide read
uint16_t val16 = inw(0x100); // 16-bit wide read
uint32_t val32 = inl(0x100); // 32-bit wide read
outb(val8, 0x100); // 8-bit wide write
outw(val16, 0x100); // 16-bit wide write
outl(val32, 0x100); // 32-bit wide write
Dealing with interrupts from userspace is not as simple. But, writing a very simple driver that can block a userspace process that does a read (or ioctl) on a special file until the interrupt fires isn't that hard. I did it once years ago. The "Linux Device Drivers" O'Reily book is a pretty good resource for these things.
davorin:
Ah nice...
Long time I wrote kernel drivers...back then in good old 2.0.x/2.4.x times with uClinux and a few MBytes RAM (o;
fisafisa:
My idea was to see whether we can run the dos apps in linux....
and even better if we can record the traffic between the application and the hardware...
Ciao
davorin:
Never used "dosbox" nor "dosemu"....and if they support some sort of "hardware hooks"...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version