Products > Test Equipment
List your test equipment "scores" here!
<< < (513/581) > >>
PartialDischarge:
That bezel is easily repairable, get some fine wire mesh (https://www.twpinc.com/80-mesh-t316-stainless-0037), cut small strips with scissors, put them to red glow with a small torch, and quickly apply the srip at the back of the bezel with tweezers just where the crack is. If you do it properly the heat melts the plastic and embeds the mesh inside, giving you a durable and strong bond, unlike glues
Ice-Tea:

--- Quote from: nctnico on September 20, 2019, 10:45:50 pm ---Why do I suddenly get the idea to mill a new bezel from wood?  >:D

--- End quote ---

I actually had the idea to have a batch of these bezels run and sell them for, say, 100€/pop. Might still do that some day..
nctnico:

--- Quote from: Ice-Tea on September 21, 2019, 10:35:09 am ---
--- Quote from: nctnico on September 20, 2019, 10:45:50 pm ---Why do I suddenly get the idea to mill a new bezel from wood?  >:D

--- End quote ---

I actually had the idea to have a batch of these bezels run and sell them for, say, 100€/pop. Might still do that some day..

--- End quote ---
For that price I expect a chrome trim  8)
tautech:

--- Quote from: nctnico on September 20, 2019, 11:30:51 am ---I just pulled the trigger on oscilloscope number 15 (if I got the count right)... this time it is a Lecroy Wavepro 7200A in 'for parts' condition for $400 on Ebay. Looks complete from the pictures but the front bezel is broken. See what the mailman drags in. This would be my first real (not rebadged) Lecroy oscilloscope.

The display doesn't work so I hope the VGA output on the rear shows some signs of life.

--- End quote ---
A brave move after all your comments over the years about LeCroy's lack of Peak detect.
I'm sure it will serve you well.  :)
nctnico:

--- Quote from: tautech on September 21, 2019, 10:45:56 am ---
--- Quote from: nctnico on September 20, 2019, 11:30:51 am ---I just pulled the trigger on oscilloscope number 15 (if I got the count right)... this time it is a Lecroy Wavepro 7200A in 'for parts' condition for $400 on Ebay. Looks complete from the pictures but the front bezel is broken. See what the mailman drags in. This would be my first real (not rebadged) Lecroy oscilloscope.

The display doesn't work so I hope the VGA output on the rear shows some signs of life.

--- End quote ---
A brave move after all your comments over the years about LeCroy's lack of Peak detect.
I'm sure it will serve you well.  :)

--- End quote ---
Well.. I didn't buy it as a general purpose oscilloscope but purely for the bandwidth / signal analysis capabilities. I don't expect to use it often. The price was just too good to let it pass.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod