Products > Test Equipment
List your test equipment "scores" here!
<< < (514/581) > >>
Ice-Tea:

--- Quote from: nctnico on September 21, 2019, 10:42:30 am ---
--- Quote from: Ice-Tea on September 21, 2019, 10:35:09 am ---
--- Quote from: nctnico on September 20, 2019, 10:45:50 pm ---Why do I suddenly get the idea to mill a new bezel from wood?  >:D

--- End quote ---

I actually had the idea to have a batch of these bezels run and sell them for, say, 100€/pop. Might still do that some day..

--- End quote ---
For that price I expect a chrome trim  8)

--- End quote ---

I payed more for one some time ago. 3D printing one is more expensive if you have it done and looks worse. What you have there is a machine of a few k€. If you want to sell it, you can probably up the price a few hundred 100€ with a decent bezel. Eh, well, don't have the cash for it right now. And maybe I'll add chrome trim  :-DD
lukier:

--- Quote from: Ice-Tea on September 21, 2019, 11:48:07 am ---I payed more for one some time ago. 3D printing one is more expensive if you have it done and looks worse. What you have there is a machine of a few k€. If you want to sell it, you can probably up the price a few hundred 100€ with a decent bezel. Eh, well, don't have the cash for it right now. And maybe I'll add chrome trim  :-DD

--- End quote ---

After I made mine I found this auction:
https://www.ebay.com/itm/273985841170

So that might be an option for you, no messy work needed and 48h of 3D printing.
nctnico:
Sorry but I wouldn't pay $70 for that. Does anyone have a 3D model for the bezel? I can ask the company I outsource 3D design & printing to if they can print it in one piece and see how much it will cost.
Martin.M:
P6042, for a handshake.

lukier:

--- Quote from: nctnico on September 21, 2019, 01:02:33 pm ---Sorry but I wouldn't pay $70 for that. Does anyone have a 3D model for the bezel? I can ask the company I outsource 3D design & printing to if they can print it in one piece and see how much it will cost.

--- End quote ---

Courtesy of Mechatrommer:
https://www.eevblog.com/forum/testgear/upgrading-mainboard-in-lecroy-dda-3000-(aka-wavepro-7300a)/msg2060719/#msg2060719

I also wouldn't pay $70, that's why I printed it myself with PLA, but had to do in 6 parts, so then gluing, putty, sanding, painting, mess etc. I thought about "outsourcing" it as you say, it would be nice to have it SLS printed in one piece, but these outsource 3D printing shops charge min 40 GBP and probably much more for such big model and that's probably not even SLS, just FDM for that price.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod