Products > Test Equipment
Looking for Lecroy Waverunner Xi series service manual
(1/5) > >>
Kirkhaan:
I've searched the forum and think this has not been asked before:

Does anyone happen to have the service manual for the Lecroy Waverunner Xi series?
Is it available publicly anyhow?
I have a Waverunner 44Xi here from 2006 which has boot issues.

The service manual will make my troubleshooting much easier  8)

Thanks in advance!
abraxa:
I haven't seen a service manual around. What boot issues do you have? Maybe it's just the hard drive and/or the data on it that's causing them.
Kirkhaan:
I'm getting attached screen at start-up.

After BIOS reset the display works again and shows me a normal startup procedure until "verifying DMI pool data".
After that the screen stays black (also on the VGA output). Normally I would expect the Windows XP start-screen.
So I guess indeed there is something corrupt on the HDD.

I guess I have to start looking into the Recovery Tools and Procedures from Lecroy...
abraxa:
If I were in your situation, I'd do the following:

- make a bootable USB stick (e.g. using LinuxLive USB Creator)
- boot the scope from the USB stick
- copy the hard drive to an external hard drive ("mkdir /mnt/sdb; mount /dev/sdb /mnt/sdb; dd if=/dev/sda /mnt/sdb/lecroy.img" or similar - just be careful, dd can wipe your harddrive if you don't know what you're doing; when in doubt, ask)
- copy the calibration data on D: to the USB stick as well, just to have it in two places because you're in trouble when you no longer have it
- reboot
- unplug the USB drive and USB stick
- follow the recovery instructions: http://cdn.teledynelecroy.com/files/manuals/scope_system_recovery_instructions.pdf

Kirkhaan:
Thanks for your help abraxa! Really appreciate it.
I plan to start working on it next week. Will keep you informed.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod