Products > Test Equipment
Low cost logic analyzer probe for Rigol MSO5000 EasyEDA project
<< < (25/30) > >>
imolnar:
Hi,

What voltage should be measured on the unloaded ProbeDet pin?

S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 10:21:40 am ---Hi,
What voltage should be measured on the unloaded ProbeDet pin?

--- End quote ---

Approximately 3.3-5 volts.  :)
imolnar:
0.4V by me.
S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 12:13:16 pm ---0.4V by me.

--- End quote ---
0.58V
If short this pin to GND, "Probe connected" message will show about 3 seconds.
imolnar:
There are no messages on my scope. I can press the LA button, but there is no change in the digit channels. :(
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod