Products > Test Equipment
Low cost logic analyzer probe for Rigol MSO5000 EasyEDA project
<< < (26/30) > >>
S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 12:54:49 pm ---There are no messages on my scope. I can press the LA button, but there is no change in the digit channels. :(

--- End quote ---
What is the model of your oscilloscope?
imolnar:
5074 with patched firmware
S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 01:28:40 pm ---5074 with patched firmware

--- End quote ---
Are you sure about the correct cable connection?
Pin 1 "Probe detection" is located on the right side in the upper row when looking at the oscilloscope.  Connect the two right pins - probe detection.
imolnar:
I hope so. The other signals are in the right place. (4V, +-2.5V, Refs).
Peter_the_diver:
Hallo everybody!
I got certain inquiries regarding technical documents of the analyzer V3 in the last time. Please find the complete set of design documents here at my website eltguy.de.
have fun!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod