Products > Test Equipment

Low cost logic analyzer probe for Rigol MSO5000 EasyEDA project

<< < (26/30) > >>

S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 12:54:49 pm ---There are no messages on my scope. I can press the LA button, but there is no change in the digit channels. :(

--- End quote ---
What is the model of your oscilloscope?

imolnar:
5074 with patched firmware

S. Petrukhin:

--- Quote from: imolnar on January 12, 2023, 01:28:40 pm ---5074 with patched firmware

--- End quote ---
Are you sure about the correct cable connection?
Pin 1 "Probe detection" is located on the right side in the upper row when looking at the oscilloscope.  Connect the two right pins - probe detection.

imolnar:
I hope so. The other signals are in the right place. (4V, +-2.5V, Refs).

Peter_the_diver:
Hallo everybody!
I got certain inquiries regarding technical documents of the analyzer V3 in the last time. Please find the complete set of design documents here at my website eltguy.de.
have fun!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod