Products > Test Equipment

Low cost logic analyzer probe for Rigol MSO5000 EasyEDA project

<< < (29/30) > >>

suarezvictor:
I think a faster way to couple digital signals is by a XOR gate used as a inverting buffer and another as non-inverting buffer, followed by a resistor networks that adapts levels
I designed such a resistor network for signals of 3V (3.3V is similar or also the same circuit will work)

Common mode voltage is 1.25V and expected termination 100ohm, for 3.5-4mA (see simulation)
XOR gate can be a fast SN74AUC1G86DCKR (1ns propagation delay)



suarezvictor:
I was able to detect 1ns pulses (see red trace) by direct connection to LVDS inputs. So that timing can be reached in a probe board using differential inputs buffered by a faster buffer, like SN65LVDS100 (up to 2gbps)
Note that same IC can be used for a CMOS to LVDS translator, the one without a termination resistor is much like an analog comparator with a bit of hysteresis (capable of 0 to 4V inputs)

andy_edin:
Hi,   This looks great - and a much better option that the Rigol probe for my limited needs. 

I have the DS1104Z Plus scope with the the 68 pin HPDB LA connector.  Has anyone tried this design (or the budget MSO5000 probe https://www.eevblog.com/forum/testgear/ms05000-budget-logic-analyzer-probe-set-design/?all) on this scope ?  Maybe there is even a PCB with a HPDB plug instead of the 40pin IDC for the MSO5000 available somewhere ?

Andrey_Ak:
Good afternoon!

Please tell me, did you say to take these drivers SN65LVDS1DBVRG4
https://www.lcsc.com/product-detail/LVDS-ICs_Texas-Instruments-SN65LVDS1DBVRG4_C50990.html

But these won't fit by any chance? SN65LVDS1DBVR
https://www.lcsc.com/product-detail/LVDS-ICs_Texas-Instruments-SN65LVDS1DBVR_C465731.html

??

Nikki Smith:

--- Quote from: andy_edin on August 27, 2023, 04:21:55 am ---Hi,   This looks great - and a much better option that the Rigol probe for my limited needs. 

I have the DS1104Z Plus scope with the the 68 pin HPDB LA connector.  Has anyone tried this design (or the budget MSO5000 probe https://www.eevblog.com/forum/testgear/ms05000-budget-logic-analyzer-probe-set-design/?all) on this scope ?  Maybe there is even a PCB with a HPDB plug instead of the 40pin IDC for the MSO5000 available somewhere ?

--- End quote ---

I've designed an improved (and cheaper) version of the board in KiCad for the MSO5000 (and new DHO900) series. I'd also like to do a version for the DS1000Z Plus series with that 68-pin connector, but I don't have that scope to test it with. Would you be interested in trying an alpha-test board Andy? Thanks
https://climbers.net/sbc/clone-pla2216-logic-probe-analyzer/

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod