Products > Test Equipment
Lower voltage for resistance measurement for FLuke 289
<< < (7/8) > >>
bdunham7:

--- Quote from: tonycstech on September 29, 2024, 12:39:53 am ---Otherwise its useless for modern electronics with multi phase controllers and processing units.
Maybe some tractor wiring or construction site measurements its best for FLUKE use but i dont see any use for it in my case. Maybe not this model.

--- End quote ---

I assure you people are using Fluke 289s on things other than tractors and construction.  Have you tried or are you willing to try any of the things I've suggested?
J-R:
https://youtu.be/YXeJ-BQnJtw?t=46
tonycstech:

--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya
J-R:

--- Quote from: tonycstech on September 29, 2024, 02:12:43 am ---
--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya

--- End quote ---
I guess there is no other way to say this, but even though you have mad repair skills, you probably need to hit the electronics books a bit...
tonycstech:

--- Quote from: J-R on September 29, 2024, 02:25:28 am ---
--- Quote from: tonycstech on September 29, 2024, 02:12:43 am ---
--- Quote from: J-R on September 29, 2024, 02:03:34 am ---https://youtu.be/YXeJ-BQnJtw?t=46

--- End quote ---
Yep, there is a live demo for ya

--- End quote ---
I guess there is no other way to say this, but even though you have mad repair skills, you probably need to hit the electronics books a bit...

--- End quote ---

All i need to know is if there is any way to hack the device internals so it would obey my will. I think firmware driven device can be hacked by altering the firmware.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod